User’s Manual 6-13
Power and Power-Up Modes
1. Be sure the computer’s power is off and all cables are disconnected.
2. Close the display panel and turn the computer upside down.
3. Remove the protective cap from the Slice Expansion Battery.
4. Open latches on the Slice Expansion Battery and fit a tab on the battery
into the docking port on the underside of the computer.
Figure 6-4 Seating the Slice Expansion Battery
5. Close the latches to secure the Slice Expansion Battery to the
computer.
When handling Slice Expansion Battery, be careful not to short circuit the
terminals. Also do not drop, hit or otherwise apply impact; do not scratch or
break the casing and do not twist or bend the latches of it.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
1. Latches 3. Docking port
2. Tab
To Next Page
Loading...
