User’s Manual 3-28
Hardware, Utilities and Options
13. Replace the keyboard and secure it using the two screws.
Figure 3-11 Replace the keyboard
14. Set the keyboard brace into its groove and hold down to secure the
latches.
15. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes, for details.
16. Turn your computer over.
17. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Security ->
System icon.
Removing a memory module (Slot A)
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.
1. Screws 3. Tabs
2. Keyboard
The slot A is reserved for main memory. Use the slot B for expanded
memory. If only one card is installed, use the slot A.
To Next Page
Loading...
