User’s Manual 3-34
Hardware, Utilities and Options
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes, if required).
5. Loosen two screws securing the hard disk drive cover in place.
6. Lift the cover up and out, and remove it from the computer.
Figure 3-17 Removing the hard disk drive cover
7. Follow the below steps to remove the hard disk drive pack as shown in
below figure.
1. Screws 4. Connector
2. Hard disk drive cover 5. Hard disk drive pack
3. Plastic tab
Never allow metal objects, such as screws, staples and paper clips, to
enter the computer. Foreign metal objects can create a short circuit, which
can cause computer damage and fire, possibly resulting in serious injury.
To Next Page
Loading...
