6-14 User’s Manual
Power and Power-Up Modes
Removing the battery pack
To replace a discharged battery pack, follow the steps below.
1. Save your work.
2. Turn the computer’s power off. Make sure the Power indicator is off.
3. Remove all cables connected to the computer.
4. Close the LCD display panel and turn the computer upside down.
5. Slide and hold the battery release latch to free the battery pack for
removal, then slide out the battery pack.
Figure 6-1 Releasing the battery pack
6. Return your computer to the upright position.
Installing the battery pack
To install a battery pack, follow the steps below.
1. Turn the computer’s power off.
2. Disconnect all cables connected to the computer.
3. Close the LCD display panel and turn the computer upside down.
■ Do not remove the battery pack while the computer is in Standby
mode. Data is stored in RAM, so if the computer loses power it will be
lost.
■ In Hibernation mode, data will be lost if you remove the battery pack or
disconnect the AC adaptor before the save is completed. Wait for the
HDD indicator to go out.
■ Do not touch the battery release latch while holding the computer. Or
you may get injured by the dropped battery pack by unintentional
release of the battery release latch.
Battery pack
Battery
release latch
Do not touch the battery release latch while holding the computer. Or you
may get injured by the dropped battery pack by unintentional release of the
battery release latch.
To Next Page
Loading...
