4-10 User’s Manual
Operating Basics
Using the USB floppy disk drive
USB floppy disk drive connects to the computer’s USB port. It
accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2, The Grand Tour, for more information.
Option or provided with some models.
Connecting USB floppy disk drive
To connect the drive, plug the floppy disk drive’s USB connector into a
computer’s USB port. Refer to Figure 4-2.
Figure 4-2 Connecting the USB floppy disk drive
Disconnecting USB floppy disk drive
When you have finished using the USB floppy disk drive, follow the
procedures below to disconnect it:
1. Wait for the indicator light to go out to make sure all floppy disk activity
has stopped.
2. Click the Safely Remove Hardware icon on the Task Bar.
3. Click USB floppy disk drive that you want remove.
Make sure that the socket is at the back side and the connector is properly
aligned with the socket. Do not try to force the connection, as doing so can
damage the connecting pins.
USB connector
USB port
If you connect the USB floppy disk drive after turning on the computer, it
will take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
If you disconnect the USB floppy disk drive or turn off the power while the
computer is accessing the drive you may lose data or damage the floppy
disk or the drive.
To Next Page
Loading...
