3-14 User’s Manual
Getting Started
Standby limitations
Standby will not function under the following conditions:
■ Power is turned back on immediately after shutting down.
■ Memory circuits are exposed to static electricity or electrical noise.
Restarting the computer
Certain conditions require that you reset the system. For example, if:
■ You change certain computer settings.
■ An error occurs and the computer does not respond to your keyboard
commands.
■ There are three ways to reset the computer system:
1. Click start then click Turn off computer. From the Turn off
computer menu select Restart.
2. Press Ctrl + Alt + Del to display the Windows Task Manager, then
select Shut Down and Restart.
3. Press the power button and hold it down for five seconds. Wait 10 to 15
seconds, then turn the power on again by pressing the power button.
Create Optical Recovery Discs
■ A writable external optical media drive that is sold separately and
compatible to the computer is required to create the Recovery Discs. It
can be purchased from TOSHIBA dealers.
■ This machine supporting the following optical disc drives for
creating optical recovery discs:
External CD-RW/DVD-ROM Drive PA3352A, PA3352C, PA3352L
External DVD Super-Multi Drive PA3402C, PA3402A, PA3402L
Slim Combo CD-R/RW&DVD-ROM PA3438U
■ Be sure to connect the AC adaptor when you create Recovery Discs.
■ Be sure to close all other software programs except the Recovery Disc
Creator.
■ Do not run software such as screen savers which can put a heavy load
on the CPU.
■ Operate the computer at full power.
■ Do not use power-saving features.
■ Do not write to the disc when the virus check software is running. Wait
for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
■ Do not use hard disk utilities, including those intended to enhance HDD
access speed. They may cause unstable operation and damage data.
To Next Page
Loading...
