EasyManua.ls Logo

Toshiba Portege Z10t-A Series - Connecting Hardware Components

Toshiba Portege Z10t-A Series
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Initial setup
Use a virus-check program and make sure it is updated regularly.
Never format storage media without checking its content - formatting
destroys all stored data.
It is a good idea to periodically back up the internal Solid State Drive
or other main storage device to external media. General storage
media is not durable or stable over long periods of time and under
certain conditions may result in data loss.
Before you install a device or application, save any data in memory to
the Solid State Drive or other storage media. Failure to do so may
result in the loss of data.
Connecting TOSHIBA Keyboard Dock
TOSHIBA Keyboard Dock provided with some models can turn your
computer into a laptop for extensibility including a physical keyboard and
more ports.
To use the computer in laptop mode, you need to connect TOSHIBA
Keyboard Dock to the computer by following the steps below:
1. Hold the computer with two hands on both the left and right sides.
2. Align the docking interface located on the computer with the docking
connector on the keyboard dock.
3. Press down the computer until it clicks into place. The docking
connector on the keyboard dock engages the docking interface on the
computer.
Figure 2-1 Connecting the keyboard dock
When you are operating in laptop mode, the computer body can be opened
to a wide range of angles for optimal viewing.
While holding down the palm rest with one hand so that the body of the
keyboard dock is not raised, slowly lift the computer body - this will allow
the angle of the display screen to be adjusted to provide optimum clarity.
User's Manual
2-3

Table of Contents

Related product manuals