4.11 Touch pad/Fingerprint sensor board 4 Replacement Procedures
PORTÉGÉ Z830/835/Satellite Z830 Maintenance Manual (960-883) [CONFIDENTIAL] 4-41
4.11 Touch pad/Fingerprint sensor board
Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-18 to 4-21.
1. Disconnect the TP board FFC from the connector CN3380 on the TP board.
2. Disconnect the TP FFC from the connector CN3240 on the fingerprint sensor board
and connector on the touch pad.
3. Disconnect the FP FFC from the connector CN3650 on the fingerprint sensor board
and connector CN9551 on the TP board.
Figure 4-18 Removing the touch pad/fingerprint sensor board (1)
TP FFC
FP FFC
TP board FFC
CN3380
CN3240
CN3650
CN9551
Connector
To Next Page
Loading...
