4.11 Touch pad/Fingerprint sensor board 4 Replacement Procedures
PORTÉGÉ Z830/835/Satellite Z830 Maintenance Manual (960-883) [CONFIDENTIAL] 4-45
Installing the Touch pad/Fingerprint sensor board
To install the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-18 to 4-21.
1. Slide the TP board to the hole of the cover assembly and secure it with the following
screws.
• M2×3B S-THIN HEAD ×2
2. Stick the insulator (INSU SQUARE) to a new fingerprint sensor board in place.
NOTE: Stick the insulator (INSU SQUARE) to the fingerprint sensor board in place as
shown in the figure below.
To Next Page
Loading...
