94 Q9 ASD Installation and Operation Manual
RX2 (AI1) Reference 2
Program Frequency Settings
This parameter is used to set the gain and bias of the RX2 (AI1) input terminal
when the RX2 (AI1) terminal is used as the control input while operating in the
Speed Control mode or the Torque Control mode.
This parameter sets the RX2 (AI1) input level that is associated with RX2 (AI1)
Frequency 2 when operating in the Speed control mode.
This value is entered as -100% to +100% of the RX2 (AI1) input signal range.
See RX2 (AI1) Reference 1 (F222) for more information on this setting when
used for Speed control.
Direct Access Number — F224
Parameter Type — Numerical
Factory Default — +100
Changeable During Run — Yes
Minimum — -100
Maximum — +100
Units — %
RX2 (AI1) Frequency 2
Program Frequency Settings
This parameter is used to set the gain and bias of the RX2 (AI1) input terminal
when the RX2 (AI1) terminal is used as the control input while operating in the
Speed Control mode.
This parameter sets RX2 (AI1) Frequency 2 and is the frequency that is associated
with the setting of RX2 (AI1) Reference 2 when operating in the Speed Control
mode.
See RX2 (AI1) Reference 1 (F222) for more information on this setting.
Direct Access Number — F225
Parameter Type — Numerical
Factory Default — 60.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
F224 F225
To Next Page
Loading...
