Toshiba Q9 - Page 41

Q9 ASD Installation and Operation Manual 31
Remote Mounting Without the Mounting Kit
Note: See Figure 24 for the dimensions and the item locations referenced in steps 1 – 7.
1. At the EOI mounting location, mark the 3.80” by 3.56” hole and the four 7/32” screw holes.
2. Cut the 3.80” by 3.56” rectangular mounting hole.
3. Drill the four 7-32” screw holes.
4. Remove the Front Panel Assembly of the ASD — using a flathead screwdriver, release the upper
retaining tabs of the EOI panel then pivot the EOI assembly away from the ASD and lift (see
Figure
23).
5. Remove the EOI from the Front Panel Assembly of step 4 — discard the assembly.
6. Attach and secure the EOI to the front side of the mounting location using the four 6-32 x 5/16” pan
head screws, the #6 split lock washers, and the #6 flat washers.
7. Install the Front Panel Connector Assembly to the ASD (see Figure 23).
8. Connect the Extender Cable from the EOI to the Front Panel Assembly.
Figure 24. EOI Remote Mounting Dimensions (inches).