Need help?Do you have a question about the Toshiba RAS-05, RAS-07 and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | RAS-05, RAS-07 |
| Category | Air Conditioner |
| Language | English |
Explains warning symbols and general safety advice for the unit.
Details electrical safety, R32 refrigerant handling, and potential hazards.
Mandates reporting installation to the local power supplier.
Provides details on the fluorinated greenhouse gases used, including R32 and GWP.
Lists all included accessory parts for indoor and outdoor units.
Illustrates the physical layout and clearances for indoor and outdoor unit installation.
Details optional parts required for specific installation scenarios.
Shows the recommended placement and type of bolts for securing the outdoor unit.
Specifies suitable locations for installing the indoor unit.
Provides guidance on placing the remote control receiver and remote control.
Instructions for preparing the wall opening and mounting the installation plate.
Guides on connecting refrigerant pipes and installing the drain hose correctly.
Explains how to remove, fix, and manage the drain hose and cap.
Step-by-step guide for hanging and securing the indoor unit onto the installation plate.
Explains how to ensure proper downward slope for the drain hose to prevent water issues.
Specifies suitable locations for installing the outdoor unit, considering space and environment.
Provides specific advice for installing the unit in cold climates.
Details the process of connecting refrigerant pipes using flaring and tightening techniques.
Specifies how to properly tighten flare nut connections using torque wrenches.
Explains the process of removing air and moisture from the refrigerant lines using a vacuum pump.
Offers important guidelines for handling the packed valves before and after refrigerant charging.
Outlines the wiring procedures for both indoor and outdoor units.
Specific instruction for reattaching the air inlet grille after internal access.
Illustrates power supply and connecting cable wiring for indoor and outdoor units.
Provides schematic diagrams for indoor and outdoor unit power supply connections.
Describes how to perform a gas leak test on flare nut connections.
Details how to initiate a test run mode for the air conditioner.
Explains how to set up multiple remote controls for separate indoor units.
Guides on enabling or disabling the auto-restart function after power failure.
Provides general instructions for installation work.
Lists conditions and restrictions for reusing existing refrigerant pipes.
Instructions on sealing pipes and adjusting flare nut/machining sizes for R32 compatibility.
To Next Page