Toshiba RAS-07EAH - Heating;Cooling;Fan Only Operation

– 22 –
8-6. Heating/Cooling/Fan Only Operation
8-6-1. Operation Steps
Start
• The OPERATION lamp (green) on the display
panel of the indoor unit starts flashing.
(1) Mode button
• Select HEAT, COOL or FAN ONLY.
(2) TEMP. button
• Push the TEMP. button.
• Cooling 21°C or higher.
(3) FAN button
• Select any of the “AUTO”, “LOW”, “MED” and
“HIGH”.
(4) START/STOP button
• Push this button again to stop the air condi-
tioner.
• The OPERATION lamp (green) on the display
panel of the indoor unit lights. The operating
mode is selected in accordance with the room
temperature and operation starts after approxi-
mately 3 minutes. (If you select FAN ONLY
mode, the unit will start immediately.)
Stop: START/STOP button
• Push this button again to stop the air conditioner.
Fig. 8-10
Note:
• The FAN ONLY mode does not control tempera-
ture. Therefore, perform only steps (1), (3) and
(4) to select this mode.
MODE
TEMP.
FAN
COOL
AUTO
START/STOP
ECONO. FAN
AUTO SET
MODE
TIMER
ON OFF RSV CNL
TOSHIBA
TEMP.
(4)
(3)
(2)
(1)