Toshiba RAS-10SAVP-ND - OPERATIONAL AND INSTALLATION CAUTIONS; Installation Cautions; Operation Cautions

4
EN
3 OPTIONAL PARTS, ACCESORIES AND TOOLS
Optional Installation Parts
Part Code Parts name Q’ty
Refrigerant piping
1 ea.
Indoor unit name
Liquid side
(Outer diameter)
Gas side
(Outer diameter)
RAS-10SKVP-ND, RAS-13SKVP-ND 6.35 mm 9.52 mm
RAS-16SKVP-ND 6.35 mm 12.7 mm
Shield pipe (for extension drain hose) (polyethylene foam, 6 mm thick) 1
Attachment bolt arrangement of outdoor unit
• Secure the outdoor unit with the attachment bolts and nuts if the unit is
likely to be exposed to a strong wind.
• Use φ8 mm or φ10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple to the
base plate of the outdoor unit before installing it.
Accessory and Installation Parts
Part No. Part name (Q’ty) Part No. Part name (Q’ty) Part No. Part name (Q’ty)
a
Installation plate x 1
d
Remote controller holder x 1
g
Remote controller holder
mounting screw
φ3.1 x 16L x 2
b
Wireless remote controller x 1
e
Plasma pure filter x 1
h
Drain nipple* x 1
(RAS-10SAVP-ND,
13SAVP-ND, 16SAVP-ND)
c
Battery x 2
f
Mounting screw
φ4 x 25L x 6
i
Water-proof rubber cap* x 2
(RAS-10SAVP-ND,
13SAVP-ND, 16SAVP-ND)
Others Name This model is not equipped with an
extension drain hose.
Option:
For the extension drain hose, use the
optionally available RB-821SW or a
commercially available one.
Parts marked with asterisk (*) are packaged with the
outdoor unit.
Owner’s manual
Installation manual
Important information
and warning*
B/W strips
(Energy efficiency labels)
Y
Z
Suction side
Diffuser
Drain hole
(h)
Elongated drain
hole
(i)
InstallationManual.book Page 4 Tuesday, January 9, 2007 3:22 PM