19 EN
Normally, the front panel, moving panel, and air flow louvers do not need to be removed. However, use the procedure below if removal
of these parts is necessary.
Removing the front panel and moving panel
1. Open the moving panel, and support the moving panel by the panel support on the right side.
2. Remove the four set screws on the front panel.
3. Insert your thumb into the air outlet bottom section, and lift up the front panel bottom.
4. Close the moving panel to remove the clips on the top side as shown below.
Press your finger down on the clip on the front panel top, and lift up the panel back edge so that the clip is released (5 locations).
7 REMOVING THE MAIN PARTS
CAUTION
Before removing the front panel, moving panel, or air flow louvers, be sure to stop operation of the air conditioner and unplug
the power supply.
Moving panel
Panel support
Front panel
Clipa Clipb
Clipc
Clipd
Clipe
To Next Page
Loading...
