FILE NO. SVM-06009
1) Perform the common procedure 1
2) Remove the capacitor band. (1 screw ∅4 x 10L)
3) Disconnect the lead wires from the capacitor
terminal.
1) Perform the common procedure 1
2) Remove the fixing screw. (1 screw ∅4 x 10L)
3) Disconnect the lead wires from the capacitor
terminal.
1) Perform the common procedure 1
2) Remove the fixing screw. (2 screws ∅4 x 16L)
3) Disconnect the lead wires from the terminal.
1) Perform the common procedure 1
2) Remove the fixing screw. (1 screws ∅4 x 10L)
3) Disconnect the lead wires from the terminal.
2 Running
capacitor
for compressor
3 Running
capacitor
for fan motor
4 Magnetic
contactor
5 Spark killer
(Cooling only model)
Spark killer
Running capacitor
for compressor
Running capacitor
for fan motor
Magnetic contactor
Cooling only model
Procedures
Remarks
Part name
No.
Heat pump model
1) Perform the common procedure 1
2) Remove the fixing screw. (2 screws ∅4 x 10L)
3) Disconnect the housing from the P.C. Board.
1) Perform the common procedure 1
2) Disconnect the lead wires from the P.C. Board.
3) Remove P.C.Board after unhooking 4 clams.
6 Transformer
(Heat pump model)
7 Transformer
(Heat pump model)
Running capacitor for
compressor
Running capacitor
for fan motor
Magnetic
P.C. Board
Transformer
− 67 −
To Next Page
Loading...
