– 21 –
FILE NO. SVM-01010
7-6. Auto Restart Function
The indoor unit is equipped with an automatic restart-
ing function which allows the unit to restart operating
with the set operating conditions in the event of power
supply being accidentally shut down. The operation will
resume without warning three minutes after power is
restored.
This function is not set to work when shipped from the
factory. Therefore it is necessary to set it to work.
7-6-1. How to set auto restart function
To set the auto restart function, proceed as follows:
The power supply to the unit must be on; the function will
not set if the power is off.
Push the [TEMPORARY] button located in the center of
the front panel continuously for three seconds.
The unit receives the signal and beeps three times.
The unit then restarts operating automatically in the event
of power supply being accidentally shut down.
When the unit is on standby (Not operating)
• While this function is being set, if the unit is in
operation, the orange lamp is on.
• This function can not be set if the timer operation
has been selected.
• When the unit is turned on by this function, the
louver will not swing even though it was swinging
automatically before shutting down.
→
→
Operation
Push [TEMPORARY] button for
more than three seconds.
Motions
The unit is on standby.
The unit starts to operate. The green lamp is on.
After approx. three seconds,
The unit beeps three times The lamp changes from
and continues to operate. green to orange.
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it off.
TEMPORARY button
0
3S
When the unit is in operation
→
→
Operation
Push [TEMPORARY] button for
more than three seconds.
Motions
The unit is in operation. The green lamp is on.
The unit stops operating. The green lamp is turned off.
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote control to turn it on.
TEMPORARY button
0
3S
• While the filter check lamp is on, the TEMPORARY
button has the function of filter reset button.
To Next Page
Loading...
Need help?
General
