Toshiba RAS-B10G3KVSG-E - Menu Setup: Timer and Fireplace; Timer Off Operation

4
9.6 TIMER OFF OPERATION
To set the timer OFF when the air conditioner is operating.
1. Press MENU button for enter menu setting and press TEMP. button to select
TIMER OFF.
Blink both triangle and
feature mark Feature
not yet set
2. Enter TIMER set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
3. Select TIMER OFF by press TEMP. button.
Can select TIMER OFF from 0.5 - 12hrs.
4. Con¿ rm TIMER OFF by press MENU button.
Blink only triangle
Feature already set
5. Leave from menu setting display by select EXIT.
Note:
Ɣ The setting will be saved for the next same operation.
Cancel TIMER OFF
6. During TIMER OFF already set (no.5) press MENU button and press TEMP.
button to select TIMER OFF.
Blink only triangle
Feature already set
7. Press MENU button again will cancel TIMER OFF.
Blink both triangle and
feature mark Feature
not yet set
8. Leave from menu setting display by select EXIT.
9.5 FIREPLACE OPERATION
Keep indoor unit’s fan blowing continuously during thermo off, to circulate heat
from other sources over the room. There are three setting parameters:
Default setting > Fireplace 1 > Fireplace 2
Fireplace 1:
Ɣ During thermo off period, the indoor unit’s fan will continue to run by the same
speed, previously selected by end-user.
Fireplace 2:
Ɣ During thermo off period, the indoor unit’s fan will continue to run at super-low
speed, programmed from factory.
Fireplace Operation Setting
1. Press MENU button for enter menu setting and press TEMP. button to select
FIREPLACE
°C
Blink both triangle and
feature mark Feature
not yet set
2. Enter FIREPLACE set by press MENU button.
triangle mark will stop blink and setting feature will be blink instead.
°C
3. Select FIREPLACE operation by press TEMP. button
°C
FIREPLACE 1
FIREPLACE 2
None
4. Con¿ rm selected feature by press MENU button again.
°C
Blink only triangle
Feature already set
When feature had selected will return to menu selection display triangle
mark will blink .
5. Leave from menu setting display by select EXIT.
°C
Note:
Ɣ While Fireplace operation on heating mode, indoor unit fan always runs and
cold air breezing might be occurred.
Ɣ Fireplace will operate in Heating mode only.
EN
OM_1126250234.indb 7 13/6/2565 BE 09:35