Toshiba RAS-B10N3KVP-E - Name and Functions of Indications on Remote Controller

– 49 –
1
8
10
13
5
15
9
3
4
12
11
2
14
6
9-4-3. Name and Functions of Indications on Remote Controller
[Display]
All indications, except for the clock time indicator, are displayed by pressing the button.
1 Transmission mark
This tr
ansmission mark
indicates when the
remote controller tr
ansmits signals to the indoor
unit.
2 Mode indicator
Indicates the current oper
ation mode.
(A
UTO : Automatic control, A : Auto changeover
control,
: Cool, : Dry, : Heat)
3 Temperature indicator
Indicates the temper
ature setting.
(17°C to 30°C)
4 PURE indicator
Sho
ws that the electrical air purifying operation is
in prog
ress.
5 FAN speed indicator
Indicates the selected f
an speed.
A
UTO or five fan speed levels
(
LOW , LOW
+
, MED , MED
+
,
HIGH ) can be shown.
Indicates A
UTO when the operating mode is
either A
UTO or
: Dry.
6 TIMER and clock time indicator
The time setting f
or timer operation or the clock
time is indicated.
The current time is alw
ays indicated except
dur
ing TIMER operation.
7 Hi-POWER indicator
Indicates when the Hi-PO
WER operation starts.
Press the Hi-POWER button to start and press it
again to stop the oper
ation.
8 (PRESET) indicator
Flashes
for 3 seconds when the PRESET button is
pressed dur
ing operation.
The
mark is shown when holding down the
b
utton for more than 3 seconds while the mark is
flashing.
Press another button to turn off the mark.
9 POWER-SEL
10 A, B change indicator remote controller
When the remote controller s
witching function is
set, “B” appears in the remote controller displa
y.
(When the remote controller setting is “A”, there is
no indication at this position.)
11 Comfort sleep
Indicates when comfort sleep is activaled.
Press comfort sleep button to selectter
12 Quiet
Indicates when quiet is activated.
Press Fan button to start and press it again to select
other fan speed for operation.
13 One-Touch
Indicates when one touch comfort is activated.
Press one-touch button to start the operation.
14 Swing
Indicates when louver is swing.
Press swing button to start the swing operation
and press it again to stop the swing operation.
FILE NO. SVM-12051
Indicates the selected POWER-SEL level.
( 100%,
75%,
50%)
15 ECO indicator
Indicates when the ECO is in activated.
Press the ECO button to start and press it again
to stop operation.
7