To Next PageTo Next Page
Need help?Do you have a question about the Toshiba RAS-B24B2KVG-E and is the answer not in the manual?
General| Power Supply | 220-240V, 50Hz |
|---|---|
| Refrigerant | R32 |
| Inverter | Yes |
| Type | Split Type |
| Energy Efficiency Ratio (EER) | 3.21 W/W |
| Coefficient of Performance (COP) | 3.61 W/W |
Lists optional parts required for installation.
Details the correct bolt pattern for securing the outdoor unit.
Guidelines for selecting the optimal location for the indoor unit.
Recommendations for remote control placement and potential interference.
Procedures for cutting wall holes and mounting the indoor unit's installation plate.
Instructions on shaping and preparing refrigerant pipes and drain hoses.
Specific steps for connecting piping from the left side.
Procedures for removing, attaching, and securing the drain hose.
Steps for securely attaching the indoor unit to the installation plate.
Proper methods for running drain hoses and ensuring water removal.
Criteria for choosing the best location for the outdoor unit.
Measures to protect the unit in cold climates and snowy conditions.
Guidance on accurately measuring and adding refrigerant.
Steps for creating a proper flare on refrigerant pipes.
Correct methods and torque specifications for tightening flare pipe connections.
Procedures for removing air and moisture using a vacuum pump.
Steps for pump down and essential safety precautions.
Instructions for connecting power and control cables to both units.
Specific steps to install the air inlet grille on the indoor unit.
Visual guides and safety advice for power supply and cable connections.
Procedures for verifying gas leaks and performing an initial test run.
How to manage multiple remotes and set them for specific units.
How to enable or disable the auto restart feature after power loss.
Instructions for applying a specific label to the unit.
Guidelines and conditions for reusing existing refrigerant pipes.
Cases where existing pipes must be replaced or cleaned.
Procedures for protecting pipes and re-machining flares for R32.
