Hi-POWER
SWING
MEMOFIX
FILTER
RESET CLOCK CHECK
ON
OFF SET CLR
3
1
2
AUTOMATIC OPERATION
When you set the air conditioner in AUTO mode, it will automatically select
either cooling, heating, or fan only operation depending on the outdoor
temperature. (Refer to page 15.)
In addition, fan speed is automatically controlled.
Start
1
START/STOP button
Push this button to start the air conditioner.
2
AUTO button (AUTO)
Push AUTO button.
• The OPERATION lamp (green) on the switch panel of the indoor unit
lights. The operating mode is selected in accordance with the room tempera-
ture and operation starts after approximately 3 minutes.
• If the AUTO mode is uncomfortable, you can select the desired condi-
tions manually.
Temperature and fan speed can be changed.
When it is changed, MODE is also changed from AUTO to A.
At the same time, fan speed indication is indicated.
Stop
START/STOP button
Push this button again to stop the air conditioner.
AUTOMATIC OPERATION (AUTO CHANGEOVER)
When you set the air conditioner in A mode or switch over from AUTO
operation because of some settings change, it will automatically select
either cooling, heating, or fan only operation depending on the outdoor
temperature. (Refer to page 15.)
Start
1
START/STOP button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select A.
3
Temperature button
Set the desired temperature.
• The OPERATION lamp (green) on the switch panel of the indoor unit lights.
The operation mode is selected in accordance with the room tempera-
ture and operation starts after approximately 3 minutes.
• When you select the A mode, it is unnecessary to set the fan speed.
The FAN speed display will show AUTO and the fan speed will be
automatically controlled.
• If the A mode is uncomfortable, you can select the desired conditions
manually.
Stop
START/STOP
Push this button again to stop the air conditioner.
To Next Page
Loading...
