Toshiba RAS-M16GDV-E - Basic Operation Modes; Cooling, Heating, and Fan Operations; Dry Operation Mode

10
START/STOP
PRESET
˚
C
AM
:
AUT
UT
O
MODE AUTOFAN
ECO
TIMER
TIMER
Hi-POWER SWING
MEMOFIX
FILTER
RESET CLOCK CHECK
ON OFF SET CLR
3
1
4
2
START/STOP
PRESET
˚
C
AM
:
AUT
UT
O
MODE AUTOFAN
ECO
TIMER
TIMER
Hi-POWER SWING
MEMOFIX
FILTER
RESET CLOCK CHECK
ON OFF SET CLR
3
1
2
COOLING/HEATING/FAN ONLY OPERATION
Start
1 START/STOP button
Push this button to start the air conditioner.
2 Mode select button (MODE)
Select Cool , Heat , or Fan only . (For cooling only model)
3 Temperature button
Set the desired temperature.
Cooling 21°C or higher.
Heating 28°C or lower.
When the air conditioner is in FAN ONLY operation, the temperature
display is not indicated.
4 Fan speed button (FAN)
Select one of “AUTO”, LOW , LOW
+
, MED , MED
+
,
HIGH .
• The OPERATION lamp (green) on the switch panel of the indoor unit
goes on. And operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start immediately.)
• The : Fan only mode does not control temperature.
Therefore, perform only steps 1 , 2 and 4 to select this mode.
Stop
START/STOP button
Push this button again to stop the air conditioner.
DRY OPERATION
Start
1 START/STOP button
Push this button to start the air conditioner.
2 Mode select button (MODE)
Select DRY
3 Temperature button
Set the desired temperature.
• The fan speed display indicates AUTO.
• The OPERATION lamp (green) on the switch panel of the indoor unit
lights, and operation starts after approximately 3 minutes.
Stop
START/STOP button
Push this button again to stop the air conditioner.