Toshiba RAV-HM801KRTP-E - HOW TO USE REMOTE CONTROLLER; Cooling, heating, and fan operation; Dry operation mode

7 HOW TO USE REMOTE CONTROLLER
■
Cooling/heating/fan only operation
Start
SWING FAN
4
3
1
2
1
START/STOP button ( )
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat , or Fan only .
3
Temperature button ( )
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of LOW , LOW
+
,
MED
, MED
+
, HIGH .
• The OPERATION lamp on the display panel
of the indoor unit goes on. And operation starts
after approximately 3 minutes. (If you select FAN
ONLY mode, the unit will start immediately.)
• The
: Fan only mode does not control
temperature.
• Fan speed is the same as
HIGH
.
Therefore, perform only steps 1, 2 and 4 to
select this mode.
Stop
START/STOP button ( )
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
■
Dry operation
Start
SWING FAN
3
1
2
1
START/STOP button ( )
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry .
3
Temperature button ( )
Set the desired temperature.
• The fan speed display indicates .
• The OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
Stop
START/STOP button ( )
Press this button again to stop the air conditioner.
Owner’s Manual
- 18 -