Toshiba RBC-AMS51E-EN - Basic Operation Guide; Running and Stopping Operation; Changing Fan Mode; Adjusting Temperature Settings

–6–
Lite-Vision plus Remote Controller
Owner’s Manual
EN
4 Operation
 Running operation
* Some operation modes are not available depending on the type of indoor unit.
 Changing the fan mode
* The available fan modes vary depending on the indoor unit connected.
 Changing the temperature
1 Push the [ ON/OFF] button to start
running.
2 Push the “ Mode” [ F1] button
to select the operation mode.
ÆThe operation mode changes as follows each
time the button is pushed.
3 Push the [ ON/OFF] button to stop
running.
1 Push the “ Fan speed” [ F2]
button to select the fan mode.
ÆThe fan mode changes as follows each time the
button is pushed.
Æ“ ” appears on the display when the
connected indoor unit is not equipped with the
fan mode.
Æ“ ” is not available when “Fan” is selected as
the operation mode.
1 Push the [ ∧] / [ ∨] button to adjust
the temperature.
ÆPush the [ ∧] button to raise the
temperature setting, push the [
∨] button
to lower it.
• Refer to “Set temp range limit” for the
temperature range available. (page 29)
• The temperature cannot be adjusted when
“Fan” is selected as the operation mode.
24
Room A
12:00
Mode
Fan Speed
Cool
Mode
Auto Heat Dry Cool Fan
Fan speed
Auto High LowMed
+00EH97062101_00EN.book Page 6 Saturday, March 12, 2011 8:24 AM