168
Remote control
The remote control does not work.
• The batteries in the remote control are exhausted.
→ Replace all the batteries in the remote control
(
page 12, “INSTALLATION GUIDE”).
• The light emitter of the remote control is not pointed
at the receptor of this recorder.
→ Point the emitter of the remote control at the
receptor of this recorder.
• The receptor of this recorder is located too far away
from the remote control.
→ Operate the remote control within 7 meters (23 ft)
from the receptor of this recorder.
• There are obstacles between the remote control and
this recorder.
→ Remove any obstacles.
• The receptor is disturbed by sunlight or fluorescent
light.
→ Change the place of this recorder or shield the
light.
• The remote control mode is not appropriate.
→ Adjust the remote control mode of the remote
control and this recorder (
page 46,
“INSTALLATION GUIDE”).
Clock
The clock blinks.
→ Complete the initial setting again ( page 26,
“INSTALLATION GUIDE”).
The clock does not keep time.
→ Set the time and date manually ( page 28,
“INSTALLATION GUIDE”).
Before calling service personnel (Continued)
Others
RD-XS34SB_Ope_E_p165-175 12/18/04, 5:53 PM168
To Next Page
Loading...
