31
Playback
Recording
Editing
Function setup
Others
Introduction
Library
Entering characters
The cursor may be followed by unwanted characters.
You can erase them if necessary by either of the
following measures:
Erasing characters
• Erasing all the characters on the writing board
Select “Clear All” by pressing the
/ / / buttons,
then press the ENTER button.
Alternatively, press the CLEAR button.
• Erasing one character before the cursor
Select “BkSp” by pressing the
/ / / buttons,
then press the ENTER button.
Alternatively, press the DELETE button.
(1) Press the
button to select an input mode.
(2) Press the
/ / / buttons to select a character,
then press the ENTER button.
The selected character is input on the cursor.
(3) Repeat steps (1) and (2) to enter characters.
(4) When finished, press
to save the characters.
The characters you entered appears.
Notes
• You can enter up to 64 characters.
• When unnecessary information appears, or when you want
to alter the input character, press the CLEAR button to
erase all, or press the DELETE button to erase an
unnecessary character.
RD-XS34SB_Ope_E_p025-038 12/20/04, 6:48 PM31
To Next Page
Loading...
