Toshiba RD-XS34 - Page 46

46
REC
MENU
Disc budget calculation
pm
11
6.6
D/M2
HDD
CH
3
4/10
(
Su
)
30 ::–
–
–
–
:
:
:
:
:
:
11 50
MN
9
6.6
D/M2
DVD
10
4/13
(We)
30 10 00
MN
10
2.2
D/M1
HDD
42
4/16
(
Sa
)
30 11 30
LP
8
4.6
D/M2
DVD
4
4/16
(
Sa
)
30 11 30
SP
Result Date
DVDHDD
Elapsed AvailableSelected(current)
()
DVDHDD
19:00
4/3 (Su)
Audio
RateMode
Media EndStart
e.g.
Remaining volume
1) Press REC MENU.
The REC MENU appears.
2) Press QUICK MENU.
The Quick Menu appears.
3) Press
/ to select “Disc budget calculation”
then press ENTER.
The Disc budget calculation menu appears.
4) Press
/ to select a timer program, then
press ENTER or press ADJUST.
The recorder calculates on a bar graph how much
a specific programme (identified by a check mark)
will occupy on the disc.
Pressing the ADJUST button can display or
remove the check mark.
Selected program
Available disc space
When the entry item is marked X, the
recording does not fit. Change the setting.
Correcting a timer programme
1) Press REC MENU.
The REC MENU appears.
2) Press
/ to select a timer program you want
to change, then press ENTER.
3) Press
/ to select an item, then press
ADJUST to set the item.
4) Press ENTER.
The modification is registered.
5) Press REC MENU to exit.
Important
•You cannot correct a timer programme within 5 minutes
before the recording start time. You can only delete the
timer program.
Note
•You can programme a timer recording whose start time has
already passed, unless the another programme recording
will start within 5 minutes. The portion of the program
before the recording starts cannot be saved.
Elapsed programing (using past data for
programing)
1) Press REC MENU.
The REC MENU appears.
2) Press QUICK MENU.
The Quick Menu appears.
3) Press
/ to select “Elapsed programing”,
then press ENTER.
The “Elapsed programing” list appears.
4) Press
/ to select a program, then press
ENTER.
5) Press
/ to select an item to correct, then
press ADJUST to change the value.
6) When complete, press ENTER.
7) Press REC MENU to exit.
Note
• Up to 36 past programmes are saved. Addition of a new
one deletes the oldest one.
Programming a recording (REC MENU) (Continued)
Recording
Deleting the past data for programming
1) On the REC MENU, press QUICK MENU.
2) Press
/ to select “Elapsed programing”,
then press ENTER.
The “Elapsed programing” list appears.
3) Press
/ to select a program to delete.
4) Press QUICK MENU, then
/ to select
“Elapsed programing delete”, and press
ENTER.
The selected data is deleted.
If you want to delete all data at once, select “All
elapsed programing delete”.
RD-XS34SB_Ope_E_p039-047 12/18/04, 5:43 PM46