26
EN
This unit can receive the Hyper and Oscar
frequency bands.
• If “Skip” is set to “ON”, select “Skip” using
[U \ D], then press [P]. Select “OFF” using
[U \ D], then press [L].
• If you want to decode scrambled signals, select
“Decoder” using [U \ D], then press [P]. Select
“ON” using [U \ D], then press [L].
• To store another channel, repeat steps
5 to 8.
9 Press [SETUP] to exit.
Skip a Preset Channel
You can set the unit to skip channels. You can no
longer receive or watch when you access channels
using [PROG. G\H].
1 Follow steps 1 to 4 in “Manual Tuning
(ANALOG)” on the previous page.
2 Select “Position” using [U \ D], then
press [P].
3 Select the position number you want
to skip using [the Number buttons]
or [U \ D], then press [L].
4 Select “Skip” using [U \ D], then
press [P].
5 Select “ON” using [U \ D ], then
press [L].
• To skip another channel, repeat steps 2 to 5.
6 Press [SETUP] to exit.
Move
You can replace two channels.
1 In stop mode, press [SETUP]. Select
“General Setting” using [U \ D],
then press [ENTER/OK].
2 Select “Channel” using [U \ D],
then press [ENTER/OK].
3 Select “ANALOG Channel Setup”
using [U \ D], then press [ENTER/
OK].
4 Select “Move” using [U \ D], then
press [ENTER/OK].
5 Select the position number that you
wish to move the channel to using
[U \ D], then press [ENTER/OK].
You cannot select a position number where
“– – –” appears next to the number, because
“Skip” is set to “ON” for that position number.
6 Move the channel to another position
number using [U \ D], then press
[ENTER/OK].
• To move another channel, repeat steps 5 to 6.
7 Press [SETUP] to exit.
ANALOG
ANALOG
E3NG1BD_EN.book Page 26 Thursday, April 24, 2008 3:34 PM
To Next Page
Loading...
