4 Replacement Procedures
Installing the Touch Pad
To install the Touch Pad, follow the steps below and refer to the figures in the preceding section:
1. With the top cover upside down, place the Touch Pad, the Track Pad Bracket, and LED PCB
board in position.
2. Secure the LED PCB board with two M2.5x3 silver screws.
3. Secure Track Pad Bracket with one M2.5x3 screw.
4. Connect the Touch Pad LED board FFC cable to the Touch Pad.
Satellite A70 Series Maintenance Manual 4-35
To Next Page
Loading...
