4 Replacement Procedures
4.14 Speakers
Removing the Speakers
To remove the speakers, first remove the top cover, then follow the steps below:
1. Remove the four M2x3 screws and then disconnect the speaker cables from the right and left
speakers.
Figure 4-22 Removing the speakers
2. Lift out the speakers.
Installing the Speakers
To install the speakers, follow the steps below and refer to the figure in the preceding section:
1. Seat each speaker. The speaker cases are marked with L (left) and R (right).
2. Secure each speaker with two M2x3 screws.
3. Attached the left- and right-side speaker cables to the system board.
4. Reassemble the rest of the computer.
4-36 Satellite A70 Series Maintenance Manual
To Next Page
Loading...
