4 Replacement Procedures 4.4 HDD
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble
or replace the HDD pack only if it fails.
3. Place the HDD pack on a flat surface (such as a desk), and remove the four M3x3.5
black flat head screws.
4. Place the HDD pack on a flat surface (such as a desk), and remove the chassis.
M3 0x3 5 black flat head screw..
HDD chassis
HDD
Figure 4-5 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.
4-14 Satellite/Satellite Pro/L630/L635 Maintenance Manual
To Next Page
Loading...
