4 Replacement Procedures 4.8 Top Cover
4.8 Top Cover
Removing the Top Cover
Remove the top cover according to the following procedures and Figures 4-11 and 4-12.
Turn the computer upside down and remove the following 18 screws:
- Twelve M2.5x6 black flat head screws.
- Four M2x2 black flat head screws.
M2x2 black flat head screw
M2x2 black flat head screw
M2 5x6 black flat head screw.
M2 5x6 black flat head screw.
Figure 4-11 Removing the screws from the bottom of the computer
2. Turn the computer right side up.
3. Disconnect the touch pad board flat cable from CN280.
4. Disconnect the power board flat cable from CN201.
5. Disconnect the speaker cable from CN600.
6. Lift up the top cover.
4-24 Satellite/Satellite Pro/L630/L635 Maintenance Manual
To Next Page
Loading...
