Toshiba Satellite M40 - Page 188

4.9 Display Assembly 4 Replacement Procedures
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-39
Disassembling the ODD Drive
NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it failed.
Disassemble the ODD drive according to the following procedures and Figures 4-26.
1. Remove the two M2x3 white flat-head screws.
2. Remove the bracket.
ODD bay module
M2x3
white flat-head screw
Breaket
Figure 4-26 Removing the bracket from the ODD drive
Assembling the ODD Drive
Assemble the ODD drive according to the following procedures and Figures 4-26.
1. Secure the bracket with the two M2x3 white flat-head screws.