4.14 Display Mask 4 Replacement Procedures
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-53
Installing the Display Mask
Install the display mask according to the following procedures and Figure 4-36.
1. Place the display mask in the correct position and fasten the following 25 latches, in that
order:
- Six top latches
- Five latches on each of the left and right sides
- Nine bottom latches
2. Place the display module in the correct position and fasten the following 8 screws, in that
order:
- Two M2.5x4.5 white flat-head screws on the top
- Two M2.5x4.5 white flat-head screws on bottom
3. Place the display mask in the correct position and fasten the following 4 seals, in that order:
- Two black seals on the bottom
- Two black seals on the top
To Next Page
Loading...
