Replacement Procedures
4-52 Satellite P100 Maintenance Manual (960-Q02)
4.20 LCD unit / FL inverter
CAUTION: When replacing a LCD, it is required that SVP parameter is set. Update with
the latest EC/KBC as described in Appendix H “EC/KBC Rewrite
Procedures”.
Removing the LCD unit / FL inverter
The following describes the procedure for removing the LCD unit and FL inverter (See
Figure 4-31 to 4-34).
1. Remove Screw rubber cover X4
2. Remove the following screws securing the display mask
M2.5×4.0 BIND screw X4
3. Insert your finger between the edge of the display mask and the LCD, and remove the
display mask while releasing the latches of display mask.
Figure 4-31 Removing the display mask
M 2.5X6.0 BIND screw
M2.5x4.0
To Next Page
Loading...
