Replacement Procedures
Satellite P100 Maintenance Manual (960-Q02) 4-53
4. Pull out one insulator and peel off the other one adhered to the FL inverter.
5. Disconnect the LCD harnesses from the connectors CN1 on the FL inverter.
6. Disconnect the HV harnesses from the connectors CN2 on the FL inverter.
7. Remove the FL inverter while peeling off the double-sided tape.
Figure 4-32 Removing the FL inverter
FL inverte
Insulator
Insulator (adhered)
CN2
CN1
LCD harness
HV harness
Double-sided tape
To Next Page
Loading...
