Replacement Procedures
4.2 Battery pack
Removing the battery pack
The following describes the procedure for removing the battery pack (See Figure 4-1).
CAUTION: Take care not to short circuit the terminals when removing the battery pack.
Similarly, do not drop, knock, scratch, disassemble, twist, or bend the battery
pack.
1. Turn off the power of the computer.
2. Disconnect the AC adapter and all external devices from the computer.
3. Turn the computer upside down.
4. Slide and hold the battery release latch (2) to free the battery pack after moving the
battery release lock (1) into it unlock position – pick the battery pack out of the
computer from fillister.
Release
Latch 1
Latch 2
Figure 4-1 Remove the battery pack
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
4-8
To Next Page
Loading...
