Toshiba Satellite P300 - Cover Assembly

Replacement Procedures
4.11 Cover assembly
Removing the cover assembly
The following describes the procedure for removing the cover assembly (See Figure 4-19 to
4-21).
1. Turn over the computer.
2. Remove the following screws securing the cover assembly from the back and bottom
of computer.
• M2.0×5.0 FLAT BIND screw Back x4
• M2.5×6.5 FLAT BIND screw Back x11
• M2.5×8.0 FLAT BIND screw Back x4
• M2.0×3.0 FLAT BIND screw Back x5
M2.5x8.0
M2.5x8.0
M2.5x6.5
M2.5x6.5
M2.5x8.0 M2.5x3.0 M2.5x5.0
M2.5x3.0
M2.5x5.0
M2.5x5.0
Figure 4-18 remove the screws (back)
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
4-42