Replacement Procedures
7. Remove the following screws securing the LCD unit.
• M2.5x5.0 BINK HEAD screw x4
8. With the bottom edge of the LCD unit on the display cover, lift only the top edge of
the LCD unit. After peeling off the CONDUTIVE tape, disconnect the LCD harness
from the connector on the back of the LCD.
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
56
9. Remove the LCD unit.
LCD UNIT
LCD HARNESS
Figure 4-30 Remove the LCD unit
To Next Page
Loading...
