Replacement Procedures
3. Pull out one insulator and peel off the other one adhered to the FL inverter.
4. Disconnect the LCD harnesses from the connectors CN1 on the FL inverter.
5. Disconnect the HV harnesses from the connectors CN2 on the FL inverter.
6. Remove the FL inverter while peeling off the double-sided tape.
FL inverte
Insulator
CN2
CN1
LCD harness
HV harness
Double-sided tape
Figure 4-29 Remove the FL inverter
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
55
To Next Page
Loading...
