Replacement Procedures
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
4-29
4.8 Keyboard
Removing the keyboard
The following describes the procedure for removing the keyboard (See Figure 4-8 to 4-9).
CAUTION: As the keycap may fall out, when handling the keyboard always hold it by the
frame and do not touch the keycap.
1. Turn the computer upside down
2. Loose the screw securing KBD Holder.
M2.5x3.0B Flat BIND screws x3
3. Upside down the computer.
4. Open the display.
5. Remove KBD holder. Insert your finger into the slot between the KBD holder and the
keyboard. Then, lift up the keyboard cover to remove it.
6. Insert your finger into the keyboard slot and keyboard. Then lift up the keyboard to
remove it.
7. Disconnect keyboard cable.
To Next Page
Loading...
