Replacement Procedures
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
4-45
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-19 to
4-21).
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.0×5.0 FLAT BIND screw Back x4
• M2.5×6.5 FLAT BIND screw Back x11
• M2.5×8.0 FLAT BIND screw Back x4
• M2.0×3.0 FLAT BIND screw Back x5
4. Free the cable from cable-drain when through the antenna cable to PCB hole.
To Next Page
Loading...
