User’s Manual 4-19
Operating Basics
2. Grasp the drawer gently and pull until it is fully opened.
3. Place the disc, label side up, in the drawer.
Pulling the drawer open
Inserting a disc
When the drawer is fully opened, the edge of the computer will extend slightly
over the disc tray. Therefore, you will need to turn the disc at an angle when
you place it in the tray. After seating the disc, however, make sure it lies at, as
shown in the gure above.
nDo not touch the laser lens. Doing so could cause misalignment.
nKeep foreign matter from entering the drive. Check the back edge of the
tray to make sure it carries no debris before closing the drive.
To Next Page
Loading...
