1-21
Before Operation - VCR part (Continued)
Tuning in TV Stations Manually
In certain areas of the country broadcast signals
may be too weak for your VCR’s automatic tuning
process to find or assign TV stations correctly.
You must tune in these weaker broadcast stations
manually in order for your VCR to store them.
11
Press VCR MENU.
The main menu will appear on the TV screen.
Press 1 or 2 to select the PR SET.
Press ENTER/OK.
22
Press VCR MENU.
The station table will appear.
Press 3 or 4 to select the programme number that
you want to tune (for example, PR 09).
3
Press ENTER/OK.
Press
INPUT SELECT to select C (Standard
stations) or
S (Cable stations):
C02 - C69, S01 - S41.
Enter the channel number of station that you want
to tune with
the numbered buttons or use 3 or 4
to find the required station.
44
Searching will stop when it locates a stations.
Press 2 to select MFT.
Control the fine tuning of the station by using 3 or 4.
55
Press 2 to select STATION so that you may name
your TV station.
Press ENTER/OK.
The TV station name list will appear.
66
Use D or E to select a station name from the list.
Press ENTER/OK to select it.
77
You can change a TV station name manually rather
than using the “standard” names.
Press G.
Use 3 or 4 to select letters and numbers for the
new station name.
Use 1 or 2 to move back and forth between
characters.
Press ENTER/OK.
88
Press VCR MENU, confirm the station placement.
Press VCR MENU again.
Your new TV station has now been tuned into your VCR.
If you wish to manually tune other stations repeat
stages 1 - 8.
To Next Page
Loading...
Need help?
General
