1-41
Cause
z The power cord is disconnected
z DVD or VCR button is not switched
properly.
z No disc is inserted.
z No tape is inserted.
z The TV is not set to receive DVD+VCR
signal output.
z The video cable is not connected
securely.
z The Progressive Scan is set to On on
the setup menu but is connected to a
standard(analog) television.
z The equipment connected with the
audio cable is not set to receive
DVD+VCR signal output.
z The audio cables are not connected
securely.
z The power of the equipment connected
with the audio cable is turned off.
z The Digital Audio Output is set to the
wrong position.
z The disc is dirty.
z The TV channels are not tuned in properly
z Tape heads are dirty.
z Tape is a rental or was recorded on
another VCR.
z This unit can only output 625p
Progressive scan picture.
z An unplayable disc is inserted.
z The disc is placed upside down.
z The disc is not placed within the guide.
z The disc is dirty.
z The Rating level is set.
z Is the cassette compartment empty?
z Audio mode is not set properly.
z NICAM mode is not set properly.
Correction
z Plug the power cord into the wall outlet
securely.
z Refer to page 6.
z Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
z Select the appropriate video input mode
on the TV so the picture from the
DVD+VCR player appears on the TV
screen.
z Connect the video cable into the jacks
securely.
z Set Progressive Scan to Off
(see page 19).
z Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR player.
z Connect the audio cable into the jacks
securely.
z Turn on the equipment connected with
the audio cable.
z Set the Digital Audio Output to the
correct position, then turn on the
DVD+VCR player again by pressing
++//11
.
z Clean the disc.
z Check tuning, carry out tuning again.
z Clean video heads.
z Use PR/TRK (+/-) for manual tracking
adjustment while tape is playing.
z Make sure that your TV can support
625p Progressive scan picture or set
Progressive scan to off.
z Insert a playable disc. (Check the disc
type and Regional code.)
z Place the disc with the playback side
down.
z Place the disc on the disc tray correctly
inside the guide.
z Clean the disc.
z Cancel the Rating function or change
the rating level.
z Eject the tape in.
z Select STEREO by repeatedly pressing
AUDIO on the remote control.
z Make sure NICAM in the menu is set to
AUTO for the station to be recorded.
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
The power is on, but
the DVD+VCR player
does not work.
No picture.
No sound.
The playback picture is
poor.
The DVD+VCR player
does not start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
No NICAM sound
recording
To Next Page
Loading...
Need help?
General
