Toshiba SD-V280UA - 1 Removal of Mechanical Parts and P.C. Boards; Disassembly Instructions

DISASSEMBLY INSTRUCTIONS
B1-1
1.
1-1:
REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
TOP CABINET AND FRONT CABINET
(Refer to Fig. 1-1)
1.
2.
3.
4.
5.
Remove the 5 screws 1.
Remove the Top Cabinet in the direction of arrow (A).
Disconnect the following connectors: (CP681, CP601).
Unlock the 8 supports 2.
Remove the Front Cabinet in the direction of arrow (B).
1-2: DISPLAY PCB AND OPERATION 1/2 PCB
(Refer to Fig. 1-2)
1.
2.
Remove the 11 screws 1.
Remove the Display PCB and Operation 1/2 PCB in the
direction of arrow.
1.
2.
Open Flap to 90˚ and flex in direction of arrow (A), at the
same time slide in direction of arrow (B).
Then lift in direction of arrow (C).
Fig. 1-3
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Make the short circuit on the position as shown Fig. 1-4
using a soldering. If you remove the Deck CD with no
soldering, the Laser may be damaged.
Remove the 4 screws 1.
Disconnect the following connectors:
(CP503,CP8001, CP8502).
Remove the Deck Angle in the direction of arrow (A).
Remove the 2 screws 2.
Remove the Front Shield in the direction of arrow (B).
Disconnect the following connectors:
(CP2301, CP2302 and CP2601).
Remove the 4 screws 3.
Remove the Deck CD in the direction of arrow (C).
Remove the 4 screws 4.
Remove the DVD PCB in the direction of arrow (D).
1-4: DECK CD AND DVD PCB (Refer to Fig. 1-4)
1-3: FLAP (Refer to Fig. 1-3)
(A)
(B)
(C)
Flap
1
1
1
1
(A)
2
2
2
2
(B)
1
2
2
2
2
1
Fig. 1-1
Top Cabinet
Front Cabinet
1
1
1
1
1
1
1
1
1
1
Fig. 1-2
Operation 1 PCB
Front Cabinet
Operation 2 PCB
Display PCB
Fig. 1-4
Pick Up PCB
Make the sort circuit
using a soldering.
1
1
1
1
(A)
2
Front Shield
2
(B)
Deck Angle
3
3
3
3
Deck CD
(C)
4
4
4
4
(D)
DVD PCB