Installation
Step 2: Program CTX for the Console
Strata CTX Attendant Console Installation 03/03 3
❐ FB00 – Specifies the COS, Toshiba recommends using “COS=10” for the Attendant
Console (recommended).
❐ FB01 – Press
to disable Auto Busy Redial (required).
❐ FB06 – Press
to disable this feature so that calling parties with Do Not Disturb (DND)
Override privileges cannot override the Console’s DND status (required).
❐ FB09 – Press
to enable Executive Override privileges for the console (preferred).
❐ FB10 – Press
to disable Executive Override for others calling the console (required).
❐ FB12 – Press
to enable Group Pickup (preferred).
❐ FB13 – Press
to enable Directed Station Pickup (preferred).
❐ FB14 – Press
to enable Directed Group Call Pickup (preferred).
❐ FB15 – Press
to enable Directed DN Call Pickup (preferred).
❐ FB16 – Press
to enable External Call Pickup (preferred).
❐ FB17 – Press
to enable Directed CO Call Pickup (preferred).
❐ FB20 – Press
to enable the console to switch from ringing to handsfree answerback
(preferred).
❐ FB21 – Press
to enable Privacy Override (preferred).
❐ FB23 – Press
to enable Emergency Paging (preferred).
❐ FB24 – Press
to enable the ability to Join calls (required).
❐ FB25 – Press
to enable Through Dialing (required).
❐ FB26 – Press
to enable Tandem (Trunk-to-trunk) Connections (preferred).
❐ FB27 – Press
to enable the ability to change Day/Night mode (required).
❐ FB30 – Press
to enable the ability to dial individual trunk access codes to access
specified lines (preferred).
❐ FB31 – Press
to enable access to trunk groups by trunk access codes (required).
❐ FB34 – Press
to enable use of a Short Flash signal over CO lines (required).
❐ FB35 – Press
to enable use of a Long Flash signal over CO lines (required).
❐ FB36 – Press
to enable the ability to receive Hook Flash over CO lines (required).
❐ FB38 – Press
to disable the ability of other stations to call the console using Off-hook
Call Announce (required).
To Next Page
Loading...
