Installation
Step 2: Program CTX for the Console
Strata CTX Attendant Console Installation 03/03 7
Step 2F: Set Up LAN
Enter data for Program 803 first, then enter data for Program 801 second.
1. Use Program 803 and enter the following FBs to establish one of the system ports for use as a
LAN port:
❐ FB00 – CSTA logical ports are 200~208. Choose the next available. If the CTX telephone
system software is version 1.2 or higher, scroll down and select “400 BLF” for 00 Logical
Device No.
❐ FB01 – Choose LAN device connection. Assign a device port number. When
programming from a telephone, press
6SNU
to access this parameter.
Then enter a device port number.
Note If you change the LAN port, you must reset the CTX by performing a Power Cycle or Level
2 Reset.
2. Use Program 801 and the following FBs to assign the properties of each LAN port:
❐ FB00 – Choose the device port number to be assigned. Use port assigned in above step
(Program 803, FB02).
❐ FB01 – Assign to be TCP (default).
❐ FB02 – Assign the type to be Server (default).
❐ FB03 – Asynchronous operation (default).
❐ FB04 – Assign the port to be a server that is linked to the client (1100~1107 recommended).
When you complete all Strata CTX programming, be sure to enter this same port number in
“Modify TSP Configuration” on page 13. If your CTX software is version 1.2 or higher, enter
“6000” as the 04 Server Port No. “6000” is the LAN port for BLF numbers.
❐ FB05 ~FB08 and FB10 ~FB11 – Leave at default values.
6515
6439
To Next Page
Loading...
