3. After completion of WiFi setup, it is highly recommended that default passwords be
changed and/or unused interfaces disabled.
The 4610 WiFi interface adapter provides a WLAN client connection for normal printer
operation and management, plus a separate local connection for setup through a built in access
point (referred to as the Printer Access Point or Printer AP). The following is a summary of the
operations necessary to setup the WiFi adapter. Details of each step are provided in the
following sections.
1. Connect to the Printer Access Point.
2. Log into the WiFi Conguration and Management interface
3. Setup the WiFi Client
4. Setup the WiFi IP Parameters and other options
Following completion of these steps see, “Conguring a network printer (WiFi and Ethernet)”
on page 41 for the Printer IP setup if not using DHCP for all IP parameter assignment.
Before you begin
The information needed for many of the setup steps is provided by the Test/Status Receipt. This
receipt should be printed prior to beginning setup.
Printing the Test/Status Receipt
Follow the steps below to print a test/status receipt.
1. Open the paper door, then press and hold the paper feed
buon.
2. When the printer beeps and the printer-ready indicator begins blinking, release the buon
and close the paper door.
3. Press and release the paper feed buon to print the receipt.
Table 9 shows part of a sample test receipt and highlights the items required for setup.
36 Hardware Guide for Model 1NR
To Next Page
Loading...
Need help?
General