T3400/T3400CT Maintenance Manual
2.2 Troubleshooting Flowchart
Use the flowchart in Figure 2-1 as a guide to determine which procedures to execute. Before
going through the flowchart steps, verify the following:
❑ Ask the user if a password is registered, and if it is, ask him or her to enter the pass-
word. If the user has forgotten the password, connect the printer port wraparound
board (F31PRT), then turn the POWER switch on. The computer will override the
password function by erasing the current password.
❑ Verify with the customer that Toshiba MS-DOS is installed on the hard disk. Non-
Toshiba operating systems can cause the computer to malfunction.
❑ Make sure all optional equipment is disconnected.
❑ Make sure the FDD is empty.
To Next Page
Loading...
